51-0705,20-0375,50-0242,31-0879,20-0531,51-0633
Wide
Swing Arm
Fitting and spacing curved strut set VT No. 50-0583 to stock ST style frame to use 11" fender 51-0705 swing arm, 280 x 18 Metzler and GMA Brake Pulley Combo (23-4537) that allows use of 1.5" belt.
1991-99 ST Wide Right Side Drive Swing Arm in conjunction with parts listed allows use of 280-300 rear tire with a 1.5" belt. Swing arm is 2" longer than stock ST tail section includes adjuster and 1" axle.
VT No. Price Item
51-0705
$272.00 Wide Swing Arm
20-0375
$229.00 70 T Pulley
50-0242
$172.00 Strutless Fender
31-0879
$40.00 Fender Tabs
20-0531
N/A Belt, 1.5 x 136T
51-0633
$46.00 Weld On Caliper Mount
52-0725 52-0725
52-0725
52-0725 52-0725
52-0725 52-0725 52-0725
3. Save the axis tube, swing arm bolts and bearings these can be reused.
1. Install the Proper Right Side Drive Transmission 2. Remove Wheel and Swing Arm 4. Cut Off Passenger Peg Mounts and Grind Rails Smooth 5. Mark Fender Struts and Cut off Both Sides at the Same Angle.You can re-use these later.
52-0725 52-0725
52-0725
52-0725 "280" Wheel Assembly
52-0725
7. Note that if You Swap Fender Struts From Side to Side, You Can Weld Them to Both Sides at the Same Angle.You can re-use these later.
8. Check all clearances and go.
Installation requires an experienced technician
6. Center Up Driveline, Install Brake Setup of Your Choice and Install Belt
198

PRIVACY AND POLICIES

HTML content Copyright ©2012 Mas Classics-Vintage American Motorcycle Parts All rights reserved www.masclassics.com JPG images Copyright ©2010 by Tedd Cycle, Incorporated. All rights reserved. No part of this publication may be reproduced without prior written permission of the publisher.V-Twin MFG. Brand Products - Tedd Cycle Inc, Box 473 Vails Gate, NY 12584