TC-88 Tools
16-1051 16-1276 Jims TC-88 Wrist Pin Remover allows easy removal of wrist pins on all TC-88.
VT No Price
16-1276
$134.00
16-1177
Jims TC-88 Cylinder Torque Plates lasered with correct torquing sequence and will also work on Screamin' Eagle Big Bore Cylinders.
VT No Price
16-1287
$453.00
16-1287
Jims TC-88 Connecting Rod Bushing Tool use to remove and replace wrist pin bushing without removing connecting rods from crankcase.
VT No Price
16-1051
$132.00
Fuel Pressure Gauge Adapter. Two adapters must be used to check fuel pressure on 2001 and later Softail models. Replaces 44061.
VT No. Price
16-1289
N/A
16-1289
Jims Twin Cam Case Boring Jig used for boring out Twin Cam Case sets to accept 4" Bore Cylinders. This tool is designed to be used in a heavy duty 15" drill press.Works on TC-88 A&B Crank Cases.
VT No. Price
16-1177
$732.00
16-1362
Tools for V-Rod
16-1169,16-1170,16-1171,60-0132
16-1130
Gasket Locator Tool (3 Pc Set) will align primary, cam & transmission end cover gaskets, to prevent misalignment & oil leaks.
VT No. Price
16-1362
$44.00
16-1667
Sprocket Shaft Bearing & Seal Installation Tool Adapter upgrades Jims bearing installer tool (VT No. 16-1353) for work on finesplined Twin Cam sprocket shafts.
16-1364
V-Rod Service Tools by Jims.
VT No. Price Tool
16-1130
$46.00 Clutch Alignment
16-1667
$215.00 Clutch Hub Holder
Jims Compression Release Valve Tool use this tool for machining all Twin Cam heads 1999-up for compression releases. Installs on front or rear head, with or without valves installed. Order threaded tap tool and compression releases separately.
VT No. Price Finish
16-1169
$371.00 Compression Release Tool
16-1170
$66.00 Threaded Tapping Tool
16-1171
$114.00 Compression Release Valve, pr
60-0132
N/A Machine Head and Install
  Release Valves
Allows for installation of Timken bearing (OEM# 8028) & roller bearing race assembly (OEM#24004-03) onto the sprocket shaft. For Dyna Glide; all 2007 BT.
VT No. Price
16-1364
$89.00
16-1363 Main Drive Gear Seal Installer allows installation of main drive gear oil seal on assembled transmission to proper depth. The protective sleeve included is used for protecting inner bearings of main drive for installation. For 2006-up FXD and 2007-up FLST.
VT No. Price
16-1363
$111.00
16-9280
Twin Cam 24 Tooth Crankshaft Rotating Wrench for use on all 2006-up Big Twins with 24T spline sprocket shaft to check engine timing and parts clearance.
VT No. Price
16-9280
$47.00
1233

PRIVACY AND POLICIES

HTML content Copyright ©2012 Mas Classics-Vintage American Motorcycle Parts All rights reserved www.masclassics.com JPG images Copyright ©2010 by Tedd Cycle, Incorporated. All rights reserved. No part of this publication may be reproduced without prior written permission of the publisher.V-Twin MFG. Brand Products - Tedd Cycle Inc, Box 473 Vails Gate, NY 12584